Home » How To Replace The Remote Control For A Sony KD

How To Replace The Remote Control For A Sony KD

by britshop

So, you’ve been using the same remote control for your TV set for over a decade now and it’s finally gone to pieces. Whether it’s lost its battery or just stopped working altogether, it needs replacing. But what do you do? Many people will just replace the whole remote control with a brand new one – but that might not be the right choice for everybody! Check out this article about how you can replace your remote control for the Sony KD and make do with only one.


Introduction to the Device

The Sony KD is a popular device that can be used for a variety of purposes. If your remote control is no longer working, you can replace it with the instructions below. The Sony KD has a few different parts that need to be replaced, so it is important to follow the instructions carefully.


Diagram of the Device

In Sony models KD-55X9005, KD-65X9000, KD-75X8000 and KD-85X8000 televisions, the remote is attached to the front of the television. The remote contains a few buttons and a joystick. To replace the remote, follow these steps:


  1. Remove the screws that secure the top cover to the television.
  2. Lift off the top cover.
  3. Remove the old remote control by disconnecting its power cord from the back of the television.
  4. Install the new remote control by reconnecting its power cord and installing its batteries.
  5. Replace the top cover and screw it in place.


LCD Screen on the Device

If your Sony KD has a broken LCD screen, it’s time to replace it. Replacing the LCD screen is straightforward and can be done by anyone with basic DIY skills. Here’s how to replace the LCD screen on a Sony KD: 

First, remove the battery cover screws. Then use a flathead screwdriver to pry up the upper left corner of the case. Next, use a Phillips head screwdriver to unscrew the four screws that hold down the LCD screen. Finally, lift up the LCD screen and replace it with a new one.


Button On The Remote Control

If you need to replace the remote control for a Sony KD, there are a few basic steps you’ll need to follow. First, turn off the TV and remove the power cord. Second, remove the screws that hold the front bezel on and remove it. Next, remove the back bezel and unscrew the screw that holds the remote control compartment in. Finally, remove the old remote control and replace it with a new one.


The power button and LED Indicators

If your Sony KD TV is not working, there’s a good chance that the power button is not working. If you press the power button and nothing happens, the LED indicators might not be working either. Replacement of these components can fix many problems with your TV, so it’s definitely worth investigating!



If you’re experiencing difficulty figuring out how to replace the remote control for your Sony KD television, this guide should help. By following the steps in this article, you’ll be able to get your TV working again in no time.

You may also like

Leave a Comment